I was installing crown moulding at my current kitchen remodel and thought I'd cover some tips for installing it. Let's start with those pesky outside corners. How do you get them to match up just right?
The first step is to get the cuts right. See yesterday's post for that lesson.
Then, before I work on the outside corner I like to cut the other end of each piece involved in the outside corner. This may mean a coped cut that will fit with the adjoining piece.
After making this cut and/or coping it, I like to hold it in place if possible so that the long end runs past the corner. Then, I can mark exactly where the corner is and make the cut. Even still, I may cut it just a bit long and test fit it to make sure it will be snug.
When that's finished, DON'T NAIL IT yet... Lay it aside and do the opposite piece for the corner. Cut it in the same fashion and test fit it with the first piece to make sure there will be no gaps.
that the pieces are cut to fit, lay them on the floor (or a flat work table if they'll fit). Add a bit of wood glue to one end and nail them together with small brads. I use 1" brads for this. Usually, I can get two brads in each side. You have to hold them carefully and get those nails in right or you may be taking all apart to fix it!
With the corner now assembled perfectly, you can hold the pieces in place and nail them up there. If your corner is square and the ceiling level this will leave you with an outside corner that you can be proud of, even without caulk!
By the way, this process also works great for other outside corners like baseboard, especially then there are small pieces with weird angles involved.
-Peter
Comments(1)