Home Energy Audit Checklist
We all know and recognize that saving energy is cost effective, but you may not recognize how inefficient your home really is until you conduct an energy audit. You can spot many problems in your home with a simple walk-through. Keep a checklist of areas you inspect and any problems or issues you find. This will help you prioritize your energy efficiency upgrades.
Lighting
Energy expended by lighting accounts for about 10% of your hyrdo bill. Check the wattage of the light bulbs in your home. You can exchange 100 watt bulbs and in most cases use a 60 or 75 watt bulb. Compact Fluorescent lamps for higher uses area are also recommended.
Insulation
If insulation levels are less than the recommended minimum, heat loss through the ceiling and walls in your home could be high. You likely have the insulation level in your home from the builder that was recommended at the time your home was built. This level might be inadequate by today's standards and should be upgraded, especially if you have an older home.
•1. Check the attic hatch to ensure it has the same level of insulation as the attic, and ensure is it closes tightly
•2. In the attic check to ensure ductwork and chimneys are sealed and seal any gaps with expanding foal or other permanent sealant.
•3. Check that vapor barriers are in place beneath the insulation.
•4. Ensure any vents are clear and not blocked by insulation.
•5. Check for indoor air leaks along baseboards, junctures of the walls and ceiling, or the edge of flooring
•6. Make a list of any obvious drafts. The saving from reducing drafts could range from % - 30% at year, depending on the severity of the drafts or leaks you find.
•7. Check to see if air can flow through these places: electrical outlets, switch plates, window frames, baseboards, weather stripping around doors, fireplace dampers, attic hatches and wall or window mounted air conditioners, gaps around pipes and wires, foundation seals and mail slots.
•8. Check windows and doors for air leaks. Try rattling the, as movement means possible air leaks. If you see daylight around a door or window frame, then it leaks. Seal these leaks by caulking or weather stripping. New, high efficiency windows and doors should be considered.
Heating and Cooling Equipment
Having your heating and cooling systems inspected and cleaned annually to maintain their efficiency. If you have a forced air furnace, ensure you replace the filters on a regular basis, at least every 2-3 months, especially during period of higher usage.
You should consider replacing your heating and/or cooling system with a newer higher efficient units, if they are more than 15 years old. A new unit would greatly reduce your energy consumption.
Exterior
Inspect areas where two different building materials meet, i.e. all exterior corners, where siding and chimney meet, areas where the foundation and bottom of exterior brick or siding meet. Check the caulking around exterior doors and windows and check whether the exterior storm door and primary door seal tightly. Look for any cracks in the mortar, foundation and siding and seal with appropriate material.
I had an energy audit conducted on my home and happy to learn it passsed.. there were only a few very minor things.. like the wall receptacles.. I didn't know that air could flow through and cause energy inefficiency!
Comments(1)