Murfreesboro Real Estate - How to Build a Pathway Lamppost
If you are looking for a way to spruce up the end of your driveway, then you might consider building a pathway lamppost. It is really simple to build and only requires a few simple materials to make. Simply follow the directions below and you will have a beautiful new lamppost standing at the end of your driveway in no time.
1. Cut 2 x 4 to lengths for center post and 2 side pieces
2. Cut a sharp angle on end of center post
3. Cut a slot in the center post for the wire
4. Remove wood from channel with a chisel
5. Set the cable in the groove
6. Cut twi 1 x 6 boards to length and cut 45 degree angle in end
7. Trim arms at 45 degrees and cut the four 1 x 6 boards to length
8. Layout the pieces and mark where they will go.
9. Use construction adhesive and nails to fasten the pieces together
10. Bore dowel holes through the asssmebly
11. Use adhesive and drive dowels through holes
12. Trim dowels flush with sides
13. Clamp 2 x 10 board to sturdy surface and bevel rip at 45 degrees
14. Bevel sut 2 x 10's to length for the base
15. Apply construction adhesive to base boards and fasten with nails
16. Sink post into ground with wood block and sledgehammer
17. Twist 1" hook screw under bottow of the arm
18. Hang the lantern and connect wires.
Comments(0)